Pillow block bearing units are usually a housed bearing with a machined mounting surface and are used in mechanical power transmission systems to support shafts and couplings. The shaft is parallel to the mounting surface and generally perpendicular to the mounting screws. They are a type of housed bearing unit.
The 8mm Bore Inner Ball Mounted Pillow Block Insert Bearing KP08 can be used to mount a shaft end to a fixed assembly. It is very convenient to install. There is a certain self-aligning ability for the bearing, so it can be mounted on a general accuracy rack at an angle.
With careful consideration of selection, proper installation and good maintenance, pillow block bearings can last years without the need to replace them.
Popular and widely used. Two-bolt housing with ball bearing insert for ready-to-mount installation. Setscrew locking collar for secure attachment to the guided shaft in the centre. The angle between the inner bearing and outer fixing ring angle can be varied to allow for misalignment, complex mounting arrangement, etc.
|Bore Diameter [B] (mm)||
8 × 6 × 4 cm
These units are very versatile and can be used in a wide variety of applications. It can range from shafts supported by single to several bearings units. For example:
Probots KP08 Pillow Block Bearing Mount Dimensions