L293 based Motor Driver
This is a medium power motor driver perfect for driving DC Motors and Stepper Motors. It uses the popular L293 motor driver IC. It can drive 4 DC motors on and off, or drive 2 DC motors with directional and speed control. The driver greatly simplifies and increases the ease with which you may control motors, relays, etc from microcontrollers.
It can drive motors upto 36V with a total DC current of up to 600mA. You can connect the two channels in parallel to double the maximum current or in series to double the maximum input voltage.
This motor driver uses screw terminals for easy connections, mounting holes for easy mounting, back EMF protection circuit, onboard heatsink for better heat dissipation and more efficient performance.
This motor driver is perfect for robotics and mechatronics projects for controlling motors from microcontrollers, switches, relays, etc. Perfect for driving DC and Stepper motors for micromouse, line following robots, robot arms, etc.
You may use this driver with our development boards to control DC and Stepper Motors. To use this driver with our development board, just connect the power pins on the driver to the power pins on the development board, and connect the drivers input pins to suitable IO pin on the development board. You may use our Female to Female - Jumper Wires to make the connections.
- Maximum motor supply voltage: 36V
- Maximum motor supply current: 600 mA per motor
- Onboard Heatsink for better performance
- The driver two holes of 3mm diameter for easy mounting
- User Manual