CC Debugger and Programmer for RF System-on-Chips CC2530 CC1110

₹1,149.00 Rs. 973.73 + 175.27 GST
Popular Debugger + Programmer for a number of RF Chips. Use it to program and debug your RF Chips and speed up develpment time.
In stock. 1-7 Day Delivery in India.
SKU
PRO3231
The CC Debugger is a small programmer and debugger for the TI Low Power RF System-on-Chips. It can be used together with IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging and SmartRF Flash Programmer for flash programming. The CC Debugger can also be used for controlling selected devices from SmartRF Studio.

Supported Devices:
Chips that can be programmed and simulated:
 
CC1110, CC1111
CC2430, CC2431
CC2510, CC2511
CC2530, CC2531, CC2533
CC2540, CC2541
CC2543, CC2544, CC2545
 
Chips that can be controlled by SmartRF Studio:
 
CC1120, CC1121, CC1125, CC1175
CC1100, CC1101, CC110L, CC113L, CC115L
CC2500, CC2520
 
Can be used to program PurePath chips:
 
CC8520, CC8521
CC8530, CC8531
Supported Software:
  • IAR, SmartRF Studio , SmartRF Flash Programmer , IEEE Address Programmer, PacketSniffer, PurePath Wireless, etc.
Support operating system:
  • Windows XP / Windows 7 / Windows 10 32 Bit / 64 Bit
LED Status
  • OFF: The debugger has no power or there is no valid firmware on the debugger.
  • AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
  • RED LED BLINKING: The Debugger is in Boot Recovery Mode.
  • RED LED ON: No device detected.
  • GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.
Package Included:
  • 1 x CC Debugger
  • 1 x Mini USB cable
  • 1 x 10-pin flat cable 
Write Your Own Review
You're reviewing:CC Debugger and Programmer for RF System-on-Chips CC2530 CC1110
Your Rating
Similar Products!