These E3D 3D printer Hot Ends are regarded as one of the best full metal hot ends. They are suitable for printing the widest range of print materials with excellent print results, allowing for soft flexible materials and higher temperature filaments such as polycarbonate and Nylons. They offer comparatively better print quality compared to other hotends.
These well crafted hot ends are renowned for their print quality, minimal blockading, fast response and efficient thermal properties, eliminating hot ends meltdown failures associated with PEKK/PTFE designs. This hot ends with the supplied thermistor can reach 300 degrees C (can reach 400 degree C with however may require additional electronics) and will heat from 20C to 200C in 65 seconds and the temperature control responsiveness will keep the HotEnd within 0.5 degrees C.
We also offer a large range of nozzle sizes to suit your 3D Printing needs. 0.4mm is standard comes with this hotend.
- Hotend size: 70 mm
- Material: All parts are in metal
- Weight: 80 gms (approx)
- Nozzle size: 0.4 mm
- Filament size: 1.75 mm
- Filament Support: PLA,ABS,PC,PVA,WOOD,HIPS,NYLON, Flexible, Carbon Fiber
- 12V 40W cartridge Heater
- 100K ohm NTC thermistor
- Stainless steel heat sink
- 30 * 30 mm fan with fan holder
- Has a low chance of blockage compared to other hotends
- Easy to use
- Complete J-head hotend assembly
- All metal E3D v5 hotend
- heat sink + heater + thermistor
- PTFE tube inside
- Fan + Fan holder